Launching
Setups and Quick launch
Save a launch plan under a name and reuse it, or launch a new coin on one in a single step without opening Bundle Studio.
Saved setups
A setup is everything about a launch except the coin: the buy, wallets, split, steps, settings and rules. Use the setups menu in Bundle Studio's top bar to Save this setup as a name (saving under a name you've used replaces it), or to apply one. Applying a setup replaces your steps and wallets, with an Undo.
Every launch is also kept as Last launch, and a new coin starts from it. Without one, a new coin starts from the default setup: 2.5 SOL across 5 of your wallets plus the dev (new ones if you have fewer), a varied split, all in the create's bundle, with Smart sending on.
Pin to Quick launch
Quick launch has 3 slots. Pin to Quick launch in the setups menu puts a saved setup in one; unpin one to free a slot. Once you have a saved setup, the slots sit in the footer of every page, numbered 1 to 3, beside Quick launch: press one to open a new coin with that setup filled in. The gear beside them sets what's pinned in each.
Quick launch
In the coin dialog, Quick launch picks a setup (your pinned ones as numbered pills, Last launch, or any you saved) and shows what it comes to: what it buys with, how many wallets, how much you'll hold, where it opens, what you'd lose selling straight away and what leaves your treasury, then each step in a line. Launch sends it straight away; Fine-tune in Bundle Studio opens the plan instead.
With Reuse idle wallets on (it is unless you turn it off, there or in the Quick launch slots' settings), a setup that makes new wallets takes your idle ones first, the dev included: wallets holding no coin and in no running job or launch, funded ones first. New wallets are made only for the rest.